11
SETTING PROGRAMME AND CLOCK
To start programming press and hold
CONFIG/PROG
button for 3 seconds and the following screen will
appear:
Programming starts on Monday at 00:00 and is set by choosing the required Mode for each hour of the
week. Use the
OK
button to choose between Comfort , Economy or Frost Protection modes. On the screen,
programme hours will show two blocks for Comfort, one block for Economy and no blocks for frost protection.
After choosing the temperature mode press the
+/-
buttons to select the next hour to be programmed. When
a full day has been programmed the screen moves to the next day. This is signified by a number from 1 to 7
in the top left side of the screen.
Once each day of the week has been programmed the clock must be set.
Once you have programmed 23:00 on day 7, the heater will automatically enter the time setting screen.
To select the day of the week (1=Mon, 7=Sun) press the
+/-
buttons and confirm with the
OK
button. Next
select the hour and confirm with
OK
button and then select the minutes and confirm pressing
OK
button once
more.
KEYPAD LOCKING (ANTI-TAMPER)
The keypad can be locked to prevent any unauthorised person (children, people in public places, nurseries,
offices, hotels etc.) altering the settings of the heater. To lock the keypad press and hold the + and – buttons
at the same time for 3 seconds until “Lock” appears on the screen.
Once set, any button presses will be ignored and “Lock” will be displayed on the screen.
To unlock keyboard, once again press and hold + and - for 3 seconds until the word ‘Lock’ disappears.
ADVANCED SETTINGS
To enter the advanced settings mode, press
CONFIG
button while the heater is in one of the main modes
(OFF, AUTO, MANUAL). The following window will appear:
Now press the
CONFIG
button for 5 seconds and C1 appears on the screen.
To select one of the advanced settings (C1 to C6) use the
+/-
buttons keys and choose the required mode
by pressing
OK
button. The advanced settings are:
1. C1-> Choose ºF or ºC
2. C2-> Choose Type of Control
3. C3-> Temperature Compensation
4. C4-> Firmware Version
5. C5-> Open Window Detection
6. C6-> Eco-Start
