Checking Spark Plug
•
Disconnect the spark plug wire from the spark plug.
•
Before removing the spark plug, clean the area around its base to prevent debris from entering the engine.
•
Clean carbon deposits off the electrode with a wire brush.
•
Check the electrode gap and slowly adjust to 0.80mm (0.031in.) if necessary.
•
Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).
•
Reconnect spark plug wire.
•
If spark plug is worn replace only with an equivalent replacement part. Spark plug should be replaced annually.
Repairing Leaking Connections
•
Purchase O-Ring / Maintenance kits through the nearest authorized service center and follow instructions provided with
kit.
Air Filter
•
•
•
•
.
.
WARNING!
Storing Pressure Washer
If storing pressure washer for 30 days or more follow the procedures below:
•
Add fuel stabilizer to gasoline to keep gasoline from going stale and to prevent gum deposits from forming on the
carburetor. Run engine for a couple of minutes to circulate the fuel stabilizer.
•
Add PumpSaver to protect pump from freezing or damage caused by mineral deposits.
•
•
Disconnect the spark plug wire and clean the spark plug. Leave spark plug wire disconnected.
•
•
Cover unit with a suitable protective cover to keep unit dry.
•
Store unit in a frost-free area.
MAINTENANCE
•
Never attempt to repair high pressure hose, always replace.
•
Never attempt to repair leaks with sealant, always replace O-ring or seal.
WARNING!
Water pressure produced by this unit can cut through skin and tissue leading to serious
injury and possible amputation.
21