Trim system
●
First please trim model directly on your transmitter in gyro off
mode (do not switch to other modes in trimming). But if
transmitter trim is too large, please zero the trim and adjust the
FC151 Setting
1.How to enter Setting Mode:
Turn on the transmitter, move
the throttle to its minimum; power on the model, wait until the L1
green LED ends flashing; Long Press “SET” button (2sec) to
enter Setting Mode. After that, L1 displays the corresponding
SETTING ITEM and L2 shows the corresponding SETTING
VALUE.
Roll & Aileron Movement
Pitch & Elevator Movement
Yaw & Rudder Movement
● There is no need to trim in Aerobatic mode if the model had
been trimmed well in gyro off mode.
● Do not trim in auto level mode, if model attitude in auto level
mode deviate from horizon after series of aerobatic maneuvers,
please switch to aerobatic mode or gyro off mode.
● If model attitude isn't horizontal in auto level mode all the time,
please check and adjust the mounting angle of FC151.
model by changing the length of the linkage between the servo
arm and the control horn.
- 12 -
- 11 -
