Dual XDMA7650, Installation & Owner'S Manual

Page: 6 / 28

6
XDMA7650 OPERATION
Press or any other button (except EJECT or OPEN) to turn
the unit on. Press and hold for 3 seconds to turn the unit
off.
Press SOURCE to select between AM/FM, CD player, USB,
operation of iPod and auxiliary input. Modes of operation are
shown in the display.
NOTE : CD, USB and operation of iPod modes will not appear
unless a CD is inserted or USB/iPod devices are connected.
Insert a 3.5mm connector into the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
SOURCE to select AUX mode.
The steering wheel interface input located on the back of
the head unit allows connection to the Pacific Accessory
Corporation (PAC) SWI-PS interface module (sold
separately). Visit www.pac-audio.com for details.
To configure steering wheel controls, follow the instructions
provided with the PAC SWI-PS interface module. After
installing the interface module, insert the module's 3.5mm
jack into the port on the back of the head unit.
Adjust volume using volume knob (00-46).
Press DISPLAY to select between clock and different types of
information, such as radio frequency, CD track/elapsed time
or MP3/WMA song information.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located on the front panel.
With the unit on, press and hold DISPLAY until the clock
begins to flash, then release. Press TUNE
nn
to adjust the
hours and TUNE
ll
to adjust the minutes. Press DISPLAY
momentarily to save the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10
:
00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Power On/Off
Source
Auxiliary Input
Steering Wheel Interface
Input
Volume
Display
Reset
Set the Clock
12/24-hour Clock
General Operation