2
MMC36BT
Please read entire manual before installation.
Installation
Mounting
the Controller
1. Choose a mounting location
in
the dash board or instrument panel that will
allow room behind to run
the
cables to the
black box
. Consider how you
will use the AUX IN, LINE
OUTPUTS
and USB
connector
and route the appropriate
extension
and RCA
cables to an accessible area
for installation.
3.
Once you have determined a mounting location, you will need to cut a rectangular
shaped hole in the panel (4.84” X 3.15” / 123mm X 80mm).
IMPORTANT! Do not mount the commander or black box where they are submerged in water.
4.
After the hole is cut slide the commander and wiring into the hole.
5.
Slide the included spring washers (B) over the screw posts (A) and attach the screw
posts to the back of the commander.
6. Place the “U” bracket (C) over the screw posts and secure the radio to the dash using the
included hex nuts (D). If necessary, cut the score marks (E) on either side of the mounting
bracket to custom fit the bracket length for your application.
NOTE:
Before final installation, test the wiring connections to make sure the unit
is connected properly and the system works.
7.
When the black box installation, use the 4 rubber mounting stoppers (included in package)
on the bottom of the black box. This provides clearance from surface moisture and provides
sufficient ventilation for the heat.
9.
Plug in all wiring harnesses and cables.
C
D
E
A
B
BLACK BOX
RUBBER STOPPER (4EA)
CONTROLLER
Cutout dimensions
123mm X 84mm
123.0
84.0
R5.0
2.
The contorller should be mounted to a dry, clean and flat surface.
8.
Connect the controller to the black box using the supplied 13-pin DIN cable.
