7
INSTALLATION
High-Level Input
(speaker cables)
Low-Level Input
(RCA)
Speaker Connections
#ONNECT SPEAKER WIRES OBSERVING POLARITY 4HE MINIMUM IMPEDANCE LOAD FOR THE
$!$ IS OHMS STEREO AND OHMS MONO 5SE OF LOADS LOWER THAN THESE IS NOT
recommended and may cause amplifier damage.
Input Signal Connections
Low Level Input (RCA)
,OW LEVEL 2#! INPUT SIGNAL IS PREFERRED FOR BEST PERFORMANCE 4YPICAL TRUNK
MOUNT AMPLIFIER INSTALLATIONS REQUIRE A FOOT 2#! CABLE -OST TRUCKS
AND UNDERSEAT APPLICATIONS REQUIRE A FOOT 2#! CABLE 5SING TWISTED PAIR
CONSTRUCTION 2#! CABLES WILL MINIMIZE NOISE
High Level Input
(Speaker Wire)
(IGH LEVEL INPUTS SHOULD ONLY
BE USED WHEN 2#! OUTPUTS ARE
NOT AVAILABLE FROM THE HEAD UNIT
#ONNECT THE HEAD UNIT SPEAKER
OUTPUTS TO THE HIGH LEVEL INPUT
CONNECTOR AS SHOWN BELOW 4HE
BLACK WIRE SIGNAL REFERENCE
GROUND MAY OR MAY NOT REQUIRE A
connection to chassis ground
DEPENDING ON YOUR PARTICULAR
installation.
L
R
Note:
$O NOT USE BOTH LOW AND HIGH LEVEL INPUTS
AT THE SAME TIME CONNECT ONLY ONE OR THE OTHER
Amplifier Connections
8=6CC:AH & '
8=6CC:AH ( )
HJ7LDD;:G
'"- d]b
'"- d]b
'"- d]b
