10.2
10.3
WARNING!
You can set the PAN and TILT engines at high speed on your XR250WASH.
Press menu until you see SPEE.
Press ENTER and select a speed with UP-DOWN (there are 4 speeds). Confirm by
pressing ENTER.
When you use speed 4 (the highest) PAN and TILT speed is very high and your projector
may loose its path. In this case, the encoder corrects the position.
Fan speed regulation makes it possible to reduce fan noise. However, the ambient
temperature must be less than 35° C.
If the ambient temperature is too high, two thermal sensors will turn the lamp off.
In this case, you must increase the fan speed to ensure correct cooling of your
XR250WASH.
For technical personnel only.
To operate this menu:
-Connect the projector to the DMX controller (DMX SIGNAL MUST BE CORRECTLY
RECEIVED)
-Reset the XR250WASH (reset from the display projector, not from the DMX controller!).
-While reset is working, press the MENU and ENTER keys at the same time.
Electronic calibration of the motors.
Reset EEPROM (Reset all settings. ATTENTION: by pressing this key
you must repeat all previous calibrations)
Exit from hidden menu.
12- HIDDEN MENU
Pan & Tilt speed (SPEE) (default: 2)
Fan speed (FANS)( default: 6)
12
XR250
W A S H
Up-Down
ENTER
Up-Down
ES.
ENTER
Up-Down
ENTER
Up-Down
ES.
ENTER
Up-Down
ENTER
Up-Down
ES.
ENTER
Up-Down
ENTER
ES.
ENTER
Up-Down
ENTER
ES.
ENTER
Up-Down
Up-Down
ENTER
PAN ALIGNMENT
To align pan movement
TILT ALIGNMENT
To align tilt movement
SHUTTER ALIGNMENT
To align shutter
EFFECT ALIGNMENT
Effect alignement
colour WHEEL ALIGNMENT
To align colour wheel