XD10P Cinema Audio Processor, Installation and Operation
Version 1.0
2. Operations
Caution
: Do not make any changes to internal potentiometers (pots) or switches without the
guidance of DTS or your service technician.
2.1. Select Format
Normally, automation will be programmed to select format during the show. You may also manually
change formats via the front panel. Press the appropriate format button to select a format.
Available formats:
Mono
Stereo (A-type NR
Stereo SR (SR-type NR) Use this format only if the audio was recorded in SR. The analog
format should be marked on the print.
EXT1 analog
EXT2 digital
Non-Sync 1
Non-Sync 2
Mic
2.2. Adjust Fader
Set the level for the selected format by turning the Main Fader knob on the front panel. The LED display
on the front panel will indicate the change.
2.3. Changing a Format Level Preset
Format presets are set during the setup procedure using a computer. If you need to change the setting
during the show without a computer, press and hold the appropriate format button on the front panel for
two seconds and, while continuing to press it, rotate the main fader to the desired level. Then release the
button.
This will change the preset level for that format. No other format levels will change. The LED display
will indicate the preset level. Each format can be set for a different level, if necessary.
2.4. Operation in Bypass Mode
Bypass mode is triggered automatically in case the XD10P fails, or you can intentionally put the unit into
Bypass mode due to an audio emergency. You might do this if the sound in the auditorium has noticeable
defects, such as scratchy, garbled, or crackling sounds. The cause of the problem may not be apparent – it
may be a speaker problem or a processor problem.
The auxiliary power supply
must
be connected and working before you manually switch into Bypass
mode by turning the front panel power switch off.
In Bypass mode, the audio will be providing basic optical mode – Left, Center, and Right (no Surrounds
or Subwoofer).
Aux power supply must be connected to XD10P.
1. Turn the Power switch OFF on the front panel.
2. The red Bypass indicator will flash.
1
NR = Noise Reduction
2. XD10P Operations
Document #: 9301E855001.0
2-1
Summary of Contents for XD10P
Page 80: ......
