DTS Synergy 5 Spot, User Manual, Page: 19 / 52

19
13- RDM FUNCTIONS
By using a RDM controller it is possible to read / set DMX address, DMX mode and
other parameters.
SYNERGY 5 SPOT accepts the following RDM commands:
SUPPORTED_PARAMETERS List of all supported parameters
DEVICE_INFO To read the following info:

RDM ID

Fixture type

Software version

DMX address

DMX mode

DMX channels

Total sensors
DEVICE_MODEL_DESCRIPTION Fixture model
MANUFACTURER_LABEL Manufacturer
SOFTWARE_VERSION_LABEL Motors and LED Driver software version
DMX_PERSONALITY To read / set the DMX mode
DMX_PERSONALITY_DESCRIPTION Description / details of the DMX mode
DMX_START_ADDRESS To read / set the DMX address
SENSOR_DEFINITION List of sensors:
1: LED MODULE
LED temperature (°C).
2: LED DRIVER #1
White 1 and White 2 outputs of LED
Driver board temperature (°C).
3: LED DRIVER #2
White 3 and White 4 outputs of LED
Driver board temperature (°C).
4: MICRO
Micro controller temperature (°C).
5: DC SUPPLY
Power supply output voltage (48Vdc).
SENSOR_VALUE To read / refresh the value of each sensor
DEVICE_HOURS Fixture life time
LAMP_HOURS LED life time
IDENTIFY_DEVICE LED ON at max power to identify the
fixture
14- FIRMWARE UPDATING
To update the firmware release of the SYNERGY 5 SPOT you need:
- DTS Dongle Firmware Uploader (code 03.LA.206).
-
“DTS Firmware Upgrade Utility v.2.02” program installed on PC.
- Latest firmware release available for SYNERGY 5 SPOT unit.
Updating the firmware release.
Please follow the procedure below to perform the update:
1. Connect the DTS Dongle Firmware Uploader to a spare USB port on the PC.
2. Connect the unit DMX input to the DTS Dongle Firmware Uploader DMX output with
a standard DMX cable and turn ON the unit.
3. Send the new firmware release into the unit by usin
g “DTS Firmware Upgrade
Utility v.2.02” program. At the end of the procedure, the unit will reset.
For more information please refer to an authorised DTS service centre.