DTS NicKWash 600, User Manual

Page: 17 / 36

WIRELESS
Up-Down
Up-Down ENTER
Menu
MENU ENTER DOWN
UP
20 ch
DMX SET
DMX MODE
MENU ENTER DOWN
UP
WIRELESS
UNLINK
20 ch
DMX SET
DMX MODE
OFF
WIRELESS
SELECTION
MENU ENTER DOWN UP MENU ENTER DOWN UP
ENTER
13- DISPLAY FUNCTIONS
ARC 1200
17
NICK WASH 600
WIRELESS DMX
Wieless DMX enabled / disabled.
By activating WDMX MODE, it will
be possible to control Nick Wash
600 via D.T.S. ANTENNA Wireless
DMX Transmitter (cod. 03.E1271).
WIRELESS DMX system is
already installed on Nick Wash
600 with code 03.LDR005.TWS
WIRELESS DMX system on
Nick Wsh 600 with code
03.LDR005.T and
03.LDR005.TF is available on
request.
20 ch
DMX SET
DMX MODE
ON
WIRELESS
SELECTION
MENU ENTER DOWN
UP
MENU ENTER DOWN
UP
WIRELESS DMX SYSTEM
DISABLED
WIRELESS DMX SYSTEM
ENABLED
ENTER
UNLINK = LOG OUT
ENTER
Logging on Nick Wash 600 (WIRELESS DMX must be enabled on the unit)
To log on the NICK WASH 600 in the WIRELESS system simply press and quickly release the function button on the transmitter .
The transmitter will start flashing rapidly red/green scanning for new free receivers / NICK WASH 600 units. When a NICK WASH 600
logs on to the transmitter the LINK green light on transmitter starts to flash rapidly.
After approximately 10 seconds the transmitter will jump back to normal mode and continue transmitting data. The NICK WASH 600
now try to synchronize to the transmitter.
When synchronized to the transmitter, 2 different modes are possible:
1. Antenna transmitter has detected and transmits a DMX signal, in this mode a solid green light is seen on the transmitter and solid
display is seen on NICK WASH 600.
2. No DMX signal connected, the Antenna transmitter will flash red/green; display blinking on NICK WASH 600
To log off NICK WASH 600 from a transmitter simply select UNLINK function under WIRELESS DMX MENU and press ENTER.
When NICK WASH 600 is logged off the display is blinking, meaning its available for log in on a new transmitter.
Logging out a NICK WASH 600
Select UNLINK function under WIRELESS DMX MENU and press ENTER.
When Nick Wash 600 is logged off the display is blinking, meaning its available for log in on a new transmitter.
Logging out all NICK WASH 600 linked to a transmitter
Press and hold the function button of the transmitter for about 3 seconds. When the display is blinking on Nick Wash 600, it mean
that the units are logged out.
Transmitter, Status LED
Flashing red/green, no dmx connected.
Solid green, dmx signal detected and transmitted.
Fast flashing red/green, log in mode (every free Nick Wash 600 unit, not logged in to any other transmitter, will be logged on)
NICK WASH 600 Status
Display blinking, not logged on to a transmitter (free).
Solid display, logged on to a transmitter and receiving dmx data.