7
The ice bank is supplied with the controller preset. If power supply is limited, it is possible to
set up the ice bank so that the refrigeration doesn’t run at the same tim
e as the milking plant.
Set this up before milking:
1
Ensure the mains switch is ON.
2
Rotate the chilled water pump switch to ON. This activates the pump for milk cooling.
At this point the ice should have built up.
3
Rotate the milk cooling switch to OFF.
This will stop the compressor running during milking.
4
At the end of milking, turn the chilled water pump OFF and the milk cooling switch back ON
so that ice making can resume.
The chilled water pump switch must always be OFF when doing a hot wash, or the
wash will not be effective.
1
Turn the cooling switch and chilled water pump switch to OFF. Drain the ice bank.
2
Turn the main power OFF.
3
Check and clean air and water filters and drain water from the pump bleed.
4
Check that there is no debris in the tank.
5
If you are restarting for the new season, see
Powering on the ice bank
on page 4.