ON
1
2
ON
1
2
ON
1
2
ON
1
2
1
2
3
5
7
6
8
10
4
FUNCTION n. Off On DESCRIPTION
REMARKS
While opening, after pressing P/P button the gate stops.
While closing, after pressing P/P button the gate stops.
While opening, pressing P/P button does not effect in anything.
While pause, pressing P/P button does not effect in anything.
While opening, pressing P/P button does not effect in anything.
While pause, pressing P/P button closes the gate
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
timer
safety edge
Signal lamp operates together with the motor.
After total opening, the motor closes only with manual control.
Signal lamp operates 5 seconds before the gate move.
See pt 4.3.9.
3
4
3
4
3
4
3
4
Activation of safety edge changes the direction for a few seconds.
Next move is always in direction towards opening. NC type output.
9
OFF
ON
Does not slow down in the final phase of the move.
5
5
5
5
6
6
6
6
9
9
12
12
Pressing P/P button again closes the gate.
Pressing P/P button again opens the gate.
P/P input
and C1
channel
in radio card
Universal
input
JOLLY
lamp signal
before
gate move
Auto
- closing
Photo - test
Brake
Slowing down
Auto-closing
after photo
Tab.1.
The description of DIP-SWITCHes in SWIFT6-CB driver.
11
Programowanie
CAUTION! SETTINGS CHANGE REQUIRE DRIVE RESTART BY SWITCHING MOTOR SUPPLY OFF
FOR A MOMENT OR BY SHORT CIRCUIT OF RESET PINS (15, fig.1).
open-stop
-close
open-close
While opening, after pressing P/P button the gate stops for a few seconds,
later it closes.
While closing, after pressing P/P button the gate stops for a few seconds,
later it opens.
always
opens
While closing, pressing P/P button stops the gate for a few seconds,
next the gate opens.
open-close
without reverse
while opening
While closing, pressing P/P button stops the gate for a few seconds,
next the gate opens.
After safety edge activation the driver stops, repeated closing is cancelled.
NC type input.
Closes the gate when the contact is opened and opens the gate when
the contact is closed.
photocell input
While opening and closing, photocell activation stops the gate (STOP).
Restart of the gate is needed.
wicket input
Gate partly opened for the programmed period of time
(see “programming opening for pedestrians”). NC type input.
After total opening, the motor closes the gate automatically after
programmed pause time.
Brake is used for of overcoming the inertia of heavy automation systems.
When the brake is turned on it is activated at the end of every move
of the gate.
With slowing down function activated, the motor decelerate by half
at the end of every move of the gate.
Photocells activation reduces pause time to 2 seconds no matter what
time was set earlier.
Summary of Contents for SWIFT6
Page 2: ......
