4.3. REMOTES / NUMBER WRITE TO RECEIVER
To write remotes / numbers:
ź
connect the MEMO programmer to the receiver. The BACKUP, WRITE and UPDATE LEDs will begin to
flash to indicate that the programmer is ready for operation.
ź
press the WRITE button. MEMO will first create an emergency backup of the receiver's memory. It is
signaled by a fast pulsing of the green BACKUP diode and lighting of the red WRITE diode. Then, the
process of saving remote controls / numbers to the receiver's memory will start. This is indicated by the
green BACKUP diode going off and the red WRITE diode pulsing. The end of the recording is signaled by the
blinking of the BACKUP, WRITE and UPDATE LEDs.
When writing remote controls / numbers from a file, do not disconnect the MEMO programmer
from the receiver.
Only the remote memory is copied from radio receivers. The GSM number memory and receiver
settings are copied from GSM receivers.
If errors occurred during the recording, the red WRITE diode will flash cyclically to indicate the error code
(see item 6).
The remotes / numbers from the receiver's memory will be replaced with remotes / numbers
entered from the file.
The process of writing remote controls / numbers to the receiver is preceded by creating an emergency
backup called AUTOBACK.RRF. Creating an emergency backup does not affect the remote memory
storage process.
If errors appear during backup, the process will be interrupted and the green BACKUP LED will flash
periodically to indicate an error code (see section 6).
After saving the remote controls to the receiver's memory, it is necessary to synchronize the rolling
counters of the remote controls with the receiver. When using the remote control with the receiver
for the first time, press the remote control button twice.
1
CONNECT MEMO TO
RECEIVER VIA USB CABLE
868
433
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
5
ALL LEDS BLINK
RECORDING TO
RECEIVER COMPLETED
3
BACKUP LED BLINKS
WRITE LED ON
RECORDING AUTOBACK.RRF
2
ALL LEDS PULSE
PUSH THE WRITE BUTTON
4
WRITE LED BLINKS
RECORDING REMOTES/
NUMBERS TO RECEIVER
Fig. 3.
Remotes / numbers write to the receiver.
5
