3 Audio matrices
Issue 4
Page 3.3 - 4
When using only the 5S2935 16 button-per-crosspoint control panels
Control panels are connected to Routemasters using the female 9 way ‘ D’ type
connector on the rear of the unit. Use control cable 4C009, which is available in a
variety of lengths from 10 to 50 metres. (Alternatively a control cable can be made
from a 9 way ‘ D’ type male and 15 way ‘ D’ type female using the connections
given below. Note that screened cable must be used, with the screen connected to
the shell of the ‘ D’ type connectors at both ends to meet EMC requirements.)
For more complex married systems with multiple levels of video and/or audio, the
remote control panels should be connected to the composite video matrix (or the
Y/G matrix for component video).
Altogether 4 button-per-crosspoint panels can be used to control any one output,
each panel with a unique priority level (see 5S2935
Control Panel section 4.2).
When using only the 5SX4100 XY control panels
A splitter cable (specific to your particular requirement) is supplied with each
system. This should be connected to the Routemaster(s) as shown by the labels on
its connectors and to the socket marked PL1 on the rear of the XY panel using
control cable 4C025, which is available in a variety of lengths from 10 to 50
metres. (Alternatively a control cable can be made from a 25 way ‘ D’ type male to
25 way ‘ D’ type male with pin to pin connections. Note that screened cable must
be used, with the screen connected to the shell of the ‘ D’ type connectors at both
ends to meet EMC requirements.)
.
For the simplest system when an XY panel only controls a single matrix, the
splitter cable has eight 9 way ‘ D’ type male connectors which connect to the first