3 Audio matrices
Issue 4
Page 3.2 - 2
Installation
Please read section 1.3 ‘ Safety and Pre-Installation checks’ before proceeding.
For a single level matrix, connect the inputs and outputs as shown on the rear
panel (and detailed in ‘ signal wiring’ below), then connect the mains mating IEC
connector to a suitable 230v supply (NB Earth MUST be connected at all times).
For multiple levels connect the married cable between the units being operated
together with the 4C014 married cable supplied (if not supplied see ‘ connection
for married operation’ below). If being married to other component levels ensure
the unit designated Y/G is connected appropriately so that sync is derived from
the correct level.
For units with remote control connect the appropriate Routemaster(s) to the
control panel(s) with the control cable(s) supplied. NB When video and audio
Routemaster(s) are married, the video acts as the master. Remote or local control
should be connected to the video unit. If control cables are not supplied see
‘ connection for remote control below.