DTC COMMUNICATIONS, INC.
9
COMPONENTS
Squelch
Adjustment is not usually needed. If needed, make sure the bodywire
transmitter is OFF. Loosen the locknut and use a small screwdriver to turn
the Squelch control on the TAC COM 2005 counterclockwise until the
Master Power LED turns
RED
. Then turn the adjustment slightly clockwise
until the LED turns
GREEN
. Finally test the squelch setting by transmit-
ting with the bodywire and observing the listening post receiver, to make
sure it transmits ON/OFF properly. Retighten the locknut.
RF Programming/Hot Mic
TRANSMITTER & RECEIVER/HOT MIC - This DB-15 connector attaches to
an optional serial cable to allow for programming the repeater’s transmitter
and receiver sections. (Programming is optional.) The same connector is
used to connect to the optional Hot Mic.
Antenna Connector
BNC - This RF connector allows for RF transmission.
The device comes with a mag mount antenna, however
optional 50 Ohm external VHF gain antennas can
improve performance.
Line Audio Out
RCA - This audio connector allows for connection
to a recorder or other line-level audio device.
Power/Charging Input
XLR - This connector attaches to the power cable to
allow for automotive auxiliary power. This is also
used with the external AC charger provided.
Antenna
Connector
Power/Charger
Input
Audio
Line Out
