mode;
press Set time key
：
set needed time-delay, the details is in SET TIME WAY.
Impulse mode LED
numeric display OFF moving to left. Sense, the load work for 0.5sec, the sense time
interval is adjustable, default is 50sec.
1. Slide switch to impulse mode, the unit be in impulse mode;
2. turn light control(LUX) knob to ?
（
max
）
, and sensitivity knob(SENS) to certain position;
3. Switch on power, the load doesn’t work and LED numeric display reversing 50~00., when LED
numeric display OFF moving to left, the sensor enter working state;
4. moving in the sensing range, after receiving sense signal, the sense LED lights and the load
works for 0.5sec, then the LED numeric display compute reversing time interval(example:
default 50sec and it display reversing like 050…00), when the LED numeric resume displaying
OFF moving to left and you can sense again.
5. like that, sense once every at least 50sec(you can set other time interval) , the load works for
0.5sec.
6. using remote controller:
press on key
：
make the load work always;
press off key
：
make the load stop working;
press Set time key
：
set needed sense time interval, the details is in SET TIME WAY.
connection-wire method
Install procession
·-before installing switch off power;
··press the lock-button of bottom cover with finger, and pull off the top cover(like 1)
·-connect power the load with sensor according to connection-wire method;
·-install the sensor body on selected position with screw and dilatants(like 2);
·-make top cover aim at the body and button the cover(like 3), install finish.
·-if you want to open the top cover, you should press the lock-button on both side with screwdriver and
simultaneously pull off the top over(like 4).
