A
NTI
-M
ODE
8033
CINEMA
/ 8033S-II
1. Connections and Buttons
1.1. Front panel
1. Microphone input jack.
2. LIFT Button: LIFT25 / LIFT35 / FLAT selector.
•
Short press: Selects low frequency boost mode.
•
Long press (with bypass off): Stores current settings.
•
Long press (with bypass on): Enter filter selection mode (Anti-Mode 8033S-II).
3. BYPASS Button: BYPASS selector.
•
Short press: Toggle Bypass mode (disable / enable processing)
•
Long press: Begin secondary calibration for Wide Area Correction.
•
Long press of both LIFT and BYPASS buttons: Begin main calibration.
4. PWR LED: Lit when the device is on.
•
Flashes in filter edit mode, other LEDs show selected filter (Anti-Mode 8033S-II).
5. BYPASS LED: Lit when the Anti-Mode correction and lifts are bypassed.
•
Flickers for 3dB input level warning (if flickers constantly, please reduce input level)
6. LIFT25 LED: Lit when the 15-25Hz lifting EQ (equalization) and subsonic filter is on.
•
Is dimly lit along with the LIFT35 LED when the subsonic filter is active without lift.
•
Flashes during calibration.
•
Flickers for output saturation warning (please reduce input level).
7. LIFT35 LED: Lit when the 25-35Hz lifting EQ and subsonic filter is on.
•
Is dimly lit along with the LIFT25 LED when the subsonic filter is active without lift.
•
Flickers for input overdrive warning (please reduce input level).
Level warnings create an irregular flickering of the respective LEDs. In calibration and low-pass
filter selection mode the LEDs flash on and off in a steady pace.
Anti-Mode 8033 cinema has yellow LEDs by default.
Anti-Mode 8033S-II has blue LEDs by default.
Rev. 2.0
18.06.2012
Page 4 (20)
1
2
3
4
6
5
7
