a.
On each side of the plastic TIC TAC TOE board is one small screw.
Remove those two screws and pull the plastic board off to access the nine
circuit boards.
12.
How do I replace the power strip?
a.
Unplug the machine first.
Undo the nuts on either side of the power strip
to remove the strip itself. Then unsolder or cut off the wires at the input
plug on the back of the machine. Remember which color of wire attaches
to which terminal.
b.
On the new power strip, cut the plug off and strip the insulation off of the
three stranded wires inside the machine. Solder the wires into the same
positions on the input plug. Place the power strip on the wall and reattach
the bracket to hold it to the wall.
13.
How do I replace a prize motor?
a.
Unplug the blue and white wires attached to the leads on the motor.
Unscrew the prize coil from the front of the motor and the security rod if
attached. Unscrew the two screws at the corners of the motor on the back
and remove the motor. Then place the new motor in its place.
14.
How do I clean the machine?
a.
Turn off power before cleaning of the machine.
DO NOT USE A WATER
JET TO CLEAN THIS MACHINE.
Use a damp rag and a general cleaner
to keep the machine looking good.
