USER MANUAL
VIDEO SERVER-MVS-14
Page:
16
Page:
16
Last updated: February 2008
DSE srl - Via Cigna 64, 10152 Turin, Italy
Tel. +39.011.850711 Fax +39.011.2472675 E-mail: Web [email protected]: www.dseitalia.it
To enable sending of messages you need to send a CGI operation via Internet Explorer in
the following format:
http://192.168.2.200/alertcfg?action=apply&ale rt1_enable = 1 & alert1_ip =
192.168.2.60 alert1_p & ort = 10001 & alert1_msg = Alarm message!
In this example:
192.168.2.200
is the IP address of the MVS-14 video server which will send the alarm
192.168.2.200
is the IP address of the MVS-14 video server which will send the alarm
message
alert1 (
repeated 4 times in the course of the command) is the reference to the first
alert1 (
repeated 4 times in the course of the command) is the reference to the first
alarm message. E 'can set messages 2,3 and 4 by replacing alert1 with alert2, alert3, alert4.
enable = 1
enables sending of the message. To disable sending of the message to
enable = 1
enables sending of the message. To disable sending of the message to
replace it with: enable = 0
192.168.2.60
is
192.168.2.60
is
the address where
will reside
the listening application
10001
It is the listening port of the application
10001
It is the listening port of the application
Alarm Message!
is the message to be sent in case of alarm
Alarm Message!
is the message to be sent in case of alarm
After pressing ENTER in Internet Explorer activate the alarm message will be confirmed by
the appearance of the check mark on the message activated
To disable the message just send a new command like
http://192.168.2.200/alertcfg?action=apply&ale rt1_enable = 0
Area of
detection
motion (Motion Area)
If you have enabled in the general options as video motion detection (see
above) you can access
setting the detection area by clicking on Motion Area. Only the movements detected within
the selected area will be considered for alarm generation.
Drag the mouse to define the detection window within which any intrusion will generate
an alarm. Click a corner of the window to resize the selected area if necessary Click
the right button on the area to delete (DELETE) or access detection property
(PROPERTY).
ENABLE
- Enable
ENABLE
- Enable
there
detection area
selected. The square of the area to become red-green (detection enabled). By means
of the sliders below it is possible to set the sensitivity of detection.
Caution:
because the
of the sliders below it is possible to set the sensitivity of detection.
Caution:
because the
of the sliders below it is possible to set the sensitivity of detection.
Caution:
because the
detection is enabled it is necessary to have activated the MOTION DETECTION
function in the section EVENTS / GENERAL (see above)
MOTION VECTOR THRESHOLD
- Maximum path motion. A low value corresponds to
MOTION VECTOR THRESHOLD
- Maximum path motion. A low value corresponds to
greater reactivity of the detection
SAD THRESHOLD -
Sum of absolute difference - A low value corresponds to greater
SAD THRESHOLD -
Sum of absolute difference - A low value corresponds to greater
reactivity of the detection
SENSITIVITY -
Sensitivity - A high value corresponds to greater reactivity of the
SENSITIVITY -
Sensitivity - A high value corresponds to greater reactivity of the
detection
Parameters E-mail / FTP
If you use the dispatch of events via e-mail / ftp you can set its parameters. The MVS-14
video server sends a short video clip of about three seconds recorded at the time of alarm
generation.