USER MANUAL
VIDEO SERVER-MVS-14
Page:
15
Page:
15
Last updated: February 2008
DSE srl - Via Cigna 64, 10152 Turin, Italy
Tel. +39.011.850711 Fax +39.011.2472675 E-mail: Web [email protected]: www.dseitalia.it
With the browse button to indicate the location of the firmware update file flash.bin. Press
UPDATE to start the update.
The update takes several minutes during which time the LED will flash unit. To the
term
update
the
LED
resume
the
normal operation and it can resume normal use of the video server.
CAUTION.
Before you start updating close all
the
connections
underway with the video server. To avoid
absolutely power outages during upgrade
.
absolutely power outages during upgrade
.
Events (Event)
The MVS-14 video server is equipped with
function
detection of movement (motion detection), which allows to detect an intrusion on the basis of
the change of the shot image from the camera. Following the intrusion is possible to do
things, how to send pictures by email or ftp or activate the relay output on board the video
server.
This section is divided into three groups of options:
General Event Settings (General)
This section sets the general parameters relating to the motion detection and the generation
of alarms. The video server can generate alarms in two ways: via the external input state or
through the motion analysis (motion detection).
GPIN
- Enabling from external input alarm detection (always active).
GPIN
- Enabling from external input alarm detection (always active).
GPIO input status -
Automatically detect the current state input external alarm ON /
GPIO input status -
Automatically detect the current state input external alarm ON /
OFF. The external input detection means OFF and ON if it is open if closed.
MOTION DETECTION
- From enabled to use the motion detection function which
MOTION DETECTION
- From enabled to use the motion detection function which
allows to generate an event in case of intrusion.
FTP IMAGE
- From enabled to send pictures go FTP on alarm. It posted a short video
FTP IMAGE
- From enabled to send pictures go FTP on alarm. It posted a short video
clip of about three seconds recorded at the time of alarm generation.
MAIL IMAGE
- From enabled to send pictures by email in case of alarm. It posted a
MAIL IMAGE
- From enabled to send pictures by email in case of alarm. It posted a
short video clip of about three seconds recorded at the time of alarm generation.
GPOUT -
Enabling activation relay output in case of external input alarm or motion
GPOUT -
Enabling activation relay output in case of external input alarm or motion
detection (always active). In case of external input or motion detection alarm, the alarm
output is activated (the relay closes). It is not foreseen an automatic return to the idle
state which must be restored voluntarily through the RELAY OUT command (see
below)
RELAY OUT
- This option allows you to enable / disable the relay output voluntarily.
RELAY OUT
- This option allows you to enable / disable the relay output voluntarily.
Choose ON to close the alarm relay, OFF to open it. Confirm with APPLY to
make
operational command.
ALERT STATUS MESSAGE
- This advanced option lets you send messages in case
ALERT STATUS MESSAGE
- This advanced option lets you send messages in case
of an external application alarm. The function is described in detail below
Sending alarm messages to external
application
MVS-14 provides developers the ability software applications on alarm to send up to 4
messages to as many external software applications.