12
Additional Notes
S E C T I O N 6
6.1 Trouble Conditions
The control panel always watches for possible trouble conditions. If a trouble
condition occurs, the keypad “Trouble” light will turn on and the keypad will beep.
Press [
✱
][2] to display the trouble conditions.
The following trouble conditions apply to the PC5102-433 and/or any enrolled wireless
keys.
General System Supervisory -
This trouble will be generated if the panel loses
communication with any module connected to the Keybus. The event buffer will
log a detailed description of the event.
Device Low Battery -
This trouble is generated when a wireless device exhibits a
low battery condition. Press [7] one, two, or three times to view which devices
are experiencing battery failure. An LED keypad will indicate battery failure
using zone lights 1 to 8.
6.2 Wireless Zone Low Battery Transmission
Within any transmission, the device will indicate the status of the battery. If a battery
is low, the system will indicate a Device Low Battery trouble.
The system will delay reporting the event to the central station for the number of days
programmed for
Zone Low Battery Transmission Delay
in section [370]. This will
prevent unnecessary reporting of the event if the user has been instructed on how
to replace batteries.
Replacing Batteries in Wireless Devices
1. Remove the cover of the device from its back plate.
2. Refer to the battery installation instructions on the installation sheet of each
component. Be sure to note the proper orientation of the batteries as you
install them.
3. When the fresh batteries are in place, re-attach the cover to the back plate. The
battery trouble will clear when any button is pressed after the installation of
the new batteries and the device should function normally.
NOTE
NOTE
NOTE
NOTE
NOTE: When batteries in one device need to be replaced, the batteries in all de-
vices may need to be replaced at the same time.