![background image](http://html.mh-extra.com/html/ds-produkte/os220/os220_instruction-manual_2533954028.webp)
28
Use
ATTENTION!
❐
Check the device before each use! The device may only be operated if:
– it does not exhibit any visible damages;
– no previous errors or malfunctions have occurred;
– all parts of the device are securely mounted;
❐
Kickback risk! Please absolutely observe the following precautionary measures:
– Always move the device; not the workpiece!
– Always turn the device on before you place it up against the workpiece!
– Always hold the device
fi
rmly with both hands.
– Never pull the device backwards!
– Never tilt the saw blade or scraper!
– Never use the wrong, dull or defective adapters!
❐
Before using the device, check the workpiece you would like to process for nails, screws
etc. and remove them!
❐
When working, never hold the workpiece with your hand! Clamp the workpiece in place. Do
not process any workpieces, which are too small to be clamped in place.
❐
With oscillating devices, chips etc. are not removed from the work area. This may result in
the accumulation of heat due to increased friction and consequently result in damage to the
device and material. You should therefore turn the device off periodically and remove the
chips etc. from the workpiece.
❐
Fire hazard! Never let the device operate on any one point for a prolonged period. This
may result in the accumulation of considerable heat and may even cause the workpiece to
catch
fi
re.
❐
Disconnect the mains plug from the socket before you change an adapter or put away or
transport the device. There is a risk of injury associated with inadvertently pushing the
On / Off switch.
❐
The scraper and the saw blade may only be mounted on the device so that the blade or teeth
are not pointing towards the bottom handle area in order to prevent hand lacerations. For
safety’s sake, we recommend performing work at an angle of approx. 90° on the left side up
to approx. 90° on the right side of the device when using these two adapters.
❐
Burn hazard!
The adapter mounted and the workpiece you processed may be very hot
after use. Let the adapter and the workpiece cool off before you touch them.
❐
The saw blade and the scraper are sharp! Be careful when mounting it on or removing it
from the device.
❐
Only guide the device by applying
moderate
pressure!