Drytac JetMounter Pro, Operator'S Manual

Page: 8 / 25

8
ALLOW ENOUGH WORKSPACE AROUND THE MACHINE TO BE ABLE TO FEED AND
REMOVE YOUR WORKPIECE SAFELY! It is recommended that the machine be placed so that
at least three feet of space from the front and back beyond the largest piece of material you will
use be provided to insure adequate accessibility and safety.
For example, if your work piece were a four-foot by eight-foot foam board, you would need to
allow a minimum of eleven feet of space in front and eleven feet of space in the rear of your
machine. Always consider this rule a necessity prior to beginning your work.
JetMounter ™ Pro XD Controls
1. The main On-Off switch is a Breaker located on the back of the left end case of the
machine, near the power cord entry. This switch should be in the “OFF” position when
loading or unloading adhesives or film, cleaning the rollers or performing other activities that
require close proximity of your fingers to the Nip. Use this breaker to power down after
processing is completed for each day.
2. The Control Panel Power Pad is located in the lower left corner of the control panel, which is
on the upper angled surface of the right end case. This button must be pressed first, before
activating any machine functions. When one of the Emergency Stops has been pressed
and the problem has been corrected that caused the stop to be pressed, you must
reactivate the Stop and then press the Control Panel Power Button to proceed
Pro XD Control Panel