23220 W. 84
th
St., Shawnee, KS 66227
Phone: (888) 633-1973
Brian Jennett- Tech-Line/Service Manager ext 8575
http://www.DryLam.com
27STA Instruction manual.docx Page 12 of 24
LOADING FILM
Unpack the upper and lower supply mandrels. The upper and lower mandrels are different.
The word “TOP” is stamped on the shaft of the upper mandrel and the word “LOW” is
stamped on the shaft of the lower mandrel. The ends of each mandrel are also different. The
“hanger” end fits in the bracket on the left side of the laminator. The “slot end” fits into the
tensioner on the right side.
Slide the film roll onto the mandrel by
rotating the mandrel in the opposite
direction of the gripper points, leaving
equal lengths of mandrel sticking out
of each end. The film roll will slide over
the gripper, which will keep the roll
from turning on the shaft.
Load the mandrel on the laminator by
inserting the slot end of the mandrel
into the tensioner on the right side
and then lowering the hanger end into
the bracket on the left side.
