DRUCKER DIAGNOSTICS
HORIZON 24 SERVICE MANUAL
SM016
REV A
9
Fig 6
Fig 7
Fig 8
•
Place one Aluminum spacer 30-000112 onto each stud as shown (fig 6).
•
Install the motor mount assembly onto the guard bowl studs so that the motor
wire tiedown is positioned opposite of the guard bowl splice (fig 7).
•
Install one fender washer onto each stud (fig 8).
•
Finish the assembly with one Nylok nut on each stud, and tighten to 13 in-lbs
Fig 9
Fig 10
•
Place the base assembly onto the guard bowl assembly 02-003-0-0052 with the
guard bowl splice positioned as shown (fig 9).
•
Feed the motor wire harness into the base passthrough so that the wire harness is
not pinched between the base and the guard bowl (fig 10).
Tiedown
SPLICE
SPLICE
THIS SIDE
