Druck DPI 530, User Manual

Page: 15 / 45

DPI 530 User Manual 9
K162 Issue No. 2
Switch on the a.c. power supply and check that the instrument’s display
comes on.
If the instrument’s display does not come on, isolate the power supply and
check the power supply fuse.
2.3.5 Remote Input
To set remote control, proceed as follows.
Remove the remote connector from the instrument and connect up the
remote supply (1) as shown below.
Ensure that remote control is enabled (refer to Section 2.3.4).
Insert the remote connector (1) into the remote socket.
Voltage:
Use V (+ve) and 0V.
Current:
Use I (+ve) and 0V.
Note:
Only one type of remote input can be used at a time.
1