DRUCK
TEMPERATUR
&
Leitenberger GmbH •
Bahnhofstr. 33 • D-72138 Kirchentellinsfurt •
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 •
• www.druck-temperatur.de
GERMANY
DT
www.
-Cal.net
LR
MANUAL
LTC 100
61
14.6 Cleaning
14.5 Battery Care
8.0 Datalogging Interface
8.0 Datalogging Interface
15.0 Technical Specifications
In this section you get technical information about the calibrator
.
100
LTC
LR-
Cal
Dimension & Weight
Dimension 149x34x77mm without rubber boot, 155x43x86mm with rubber boot.
Weight approx. 340 g
Environmental ranges
Working temperature range 0°C to 50°C; Storage temperature (incl. battery): -20°C to 50°C
Relative Humidity <85% (non-condensing)
Chargeable Battery
Type: Lithium Ion; Charging time: 5 hours; Battery run life approx. 5 hours, measure and
source
Charger:
Charging input 10 to 30
Mains charger
100 - 240
, 0,5 A, 50/60 Hz,
at
VDC
input:
output
VAC
:
12
1.5 A
VDC
Car charger 12
at 1 A with a cigarette lighter plug
VDC
Protection:
IP
UL
ABS
54 dust and splash proof.
94V-0 flame retardant
plastic.
NOTE:
Some devices connected to the Calibrator may emit significant conductive and radiated
noise from their terminals. Excess noise injected into the Calibrator will degrade the
accuracy. To minimise the accuracy degradation the maximum conducted noise level must
not exceet 1 Vpp when measured with an impedance of at least 1
.
M
Ω
15.1 General
Your calibrator is powered by rechargeable Lithium-Ion batteries. You can extend
their service life by following these guidelines.
1. New batteries only reach optimal performance after two or three complete
charge-discharge cycles.
2. The batteries can be recharged hundreds of times but will eventually fail.
3. Only use dealer approved batteries.
4. Do not store your calibrator in extreme heat, above 60 C as the batteries may
become unstable and rupture .
5. Dispose of used batteries in the correct manner
°
.
Do not clean the unit while it is switched on. Do not use harsh abrasives or solvents on the
unit especially on the display window. The outside of the unit may be safely wiped using a
damp cloth. Do not attempt to clean the inside of this unit.
