Page 6
4.4 ASSEMBLY/DISASSEMBLY
No pump assembly operations are envisaged.
For wall mounting ensure adequate space is available (as shown in the installation diagram) to avoid abnormal postures and
possible impacts; four fixing holes are provided with different characteristics depending on the version (see section 2.2)
Subsequently it will be necessary, as previously described, to connect the pump to the machine hydraulically and then to
connect the control panel.
During the disassembly phase ensure the tank is empty.
Disconnect the electrical and hydraulic parts.
Where the machine is to be scrapped, do not dispose of potentially polluting parts in the environment, following local
regulations for their correct disposal.
At the time of the machine being scrapped it is necessary to remove and destroy the identification plate and all other relative
documents.
4.5 REGULATION
The only parameter which can be modified is the pressure; to modify the value increase or decrease the pressure of the
command air supply.
4.6
MAINTENANCE
Having undergone rigorous testing by ourselves, the pump does not require any further maintenance. The use of lubricants free
from impurities is recommended and the periodic careful cleaning of the component parts of the pump.
Disassembly must be effected in the following manner:
1.
Disconnect the tubing attached to the pump.
2.
Remove the fixing screws and the tank and relative cover.
3.
Remove the suction filter and the relative valve.
4.
Unscrew the cylinder paying
particular attention
to the loading of the springs; the component parts of the pump unit can
then be disassembled.
5.
Remove the screws which retain the flange so releasing the complete pump unit.
In this way all component parts of the pump unit can be removed allowing the disassembly and cleaning of the release and
suction valves.
All pieces should be washed in petrol and lubricated prior to reassembly.
The following should be checked periodically:
VERIFY
WORK CYCLES
The state of lubrication
100
The oil level
200
The cleanliness of the suction filter
400
That the tank is clean and the bottom free from deposits
600
The machine does not require any special tools to carry out checks or maintenance tasks, However, it is recommended that only
tools suitable for the tasks and in good condition should be utilised (according to current regulation) to avoid injury to persons
or damage to machine parts
WARNING
:
Locate the machine in conditions which facilitate easy access.
Utilise individual protection to avoid contact with mineral oil or grease.
