DRONE ART 88025RC, Operating Instructions Manual

Page: 11 / 28

Installing Propellers And Guards | 11
9. Installing propellers and guards
Warning! Remove the flight battery before you install propellers and
guards!
Overtightening will irreversibly damage the thread in the propeller hub.
In this case you must immediately replace the propeller! Both threads
and bolts of each propeller mount / propeller must be in perfect condition
9.1 Installing
■
Only tighten the propellers by hand and little force to avoid damage.
■
The motors are reverse threaded. Propellers are tightened by turning them in the
reverse direction of the arrow mark on propeller (indicator of spinning direction of
motor).
1. Install a propeller on each motor by following the propeller diagram to the right .
▬
There is a spinning direction marking on each propeller. If propellers are installed
incorrectly, the Xtreme V2 will not fly and may behave erratically.
2. Install a propeller guard on each side as shown on the bottom right .
9.2 Removing
■
Loosen the propeller by hand and pull it off the shaft.
■
If the propeller sits too tight, slide the supplied hex tool onto the hex portion of the
motor, then loosen the propeller while countering with the hex tool.
Propeller installation
White color
propeller
Black color
propeller
Spinning mark on
Black color
propeller
Spinning mark on
Spinning mark on
White color
propeller
Spinning mark on
Tightening
direction
Tightening
direction
Tightening
direction
Tightening
direction
Propeller guard installation