DUAL RATES
DRIVING THE VEHICLE
• To slowly drive forward, pull the trigger slightly. To drive faster, pull the trigger
further.
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger.
• To turn, rotate the wheel to the left or right.
• Adjust the steering trim if the car doesn’t track straight (see below).
• When the vehicle battery becomes low, the vehicle will start to slow down.
• Allow the battery to cool before recharging.
• Make sure to turn both the vehicle and the radio off after each use.
• ALWAYS unplug the battery after each use.
Forward
Neutral
Left
Right
Brake/
Reverse
Left
Right
Forward
Reverse
DRIVING TIPS
• Always release the throttle trigger right away following a crash to prevent damaging the electronics.
• The vehicle should be operated in an open space with no people or animals nearby.
1. Install the battery into the vehicle and connect
the battery.
2. Secure the battery strap to the post using clips.
3. Switch the radio on.
4. Switch the vehicle on.
Steering Dual Rate
1. Power ON the transmitter.
2. Power ON the model.
3. Apply either the left or right steering input on the transmitter and hold that
position.
4. To add or remove steering throw input, continue to hold steering input while
adjusting the dual rate using the (+) or (-) ST button.
Throttle Dual Rate
5. Turn ON the transmitter.
6. Turn ON the model.
7. Apply either forward or reverse throttle input on the transmitter and hold that
position.
8. To add or remove throttle input, continue to hold throttle input while adjusting
the dual rate using the (+) or (-) TH button.
NOTICE
: Do not adjust the throttle dual rate while the model is powered on and
resting on a stand. Adjusting the throttle dual rate may power the motor, which
could cause damage to property or personal injury.
The transmitter allows you to adjust steering and throttle dual rates.
LINKING PROCEDURE
To link the radio to the receiver:
1. Turn on the radio, then turn on the vehicle.
2. Press the “BIND” button on the 2-n-1 ESC/Receiver unit and release. When
the LED turns from fl ashing to solid, the bind is complete.
3. Process is complete.
Bind Button
