CAMERA INSTALLATION
CAMERA WIRING CONNECTION
Proper installation of the Camera is critical to the overall view you will be able to
see from your in-cab
DRIVEN DRWC5CM
wireless monitor. In most cases the
rear-view camera mount on an RVs is mounted just below the rear top clearance
lights. If your clearance lights are too low, this shouldn’t be a problem, simply plan
to for installation of the camera at the highest point of the rear outer panel of
your RV.
Most modern-day RVs are prewired with a 12v DC power supply cable that
hidden behind a camera mount cover. If this is the case, simply remove the 4
mounting screws off the pre-mounted base, connect the simple 2 wire red and
black cables to the new harness and replace the complete mount and base with
the
DRIVEN DRWC5CM
camera by screwing it down securely with the previously
removed screws.
In the event that your RV or trailer does not come prewired with a 12v DC power
supply at the desired location, you will have to carefully run a power supply cable
to the location on your RV were you wish to mount your camera system. Plan
your wire route for under the RV trailer. Be sure to avoid areas that could be
affected by heat or abrasion. Make sure to properly fuse the power supply cable
at its origin.
Once the camera is powered up, follow the pairing instructions provided with the
DRIVEN DRWC5CM
wireless monitor. Align the camera and test the angle of the
view. Make sure to adjust the angle several times to check your options. Once you
have chosen the specific angle for the camera you are good to go.
Camera Wiring Connection
6
Summary of Contents for DRWC5CM
Page 7: ...NOTES ...
