8
On receiving a signal from the transmitter, the receiver enters in OPERATION mode;
the following LED’s will light up on the receiver:
POWER: ON, indicates that the power supply is correct.
HARDOK: ON, indicates that defects have not been detected on the
board.
SIGNAL:
ON, indicates that it is receiving a RF signal at the working
frequency.
DATA:
When ON indicates that the data received has a correct
format.
ID:
When ON indicates that the receiver has recognized the
transmitter’s identification code.
Now, the STOP relays KSTOP1 and KSTOP2
will be activated.
The
K2/START and K12 relays are activated when the start button is pushed in.
Press on any of the transmitter’s motion buttons and its corresponding relay
will be activated.
Check to make sure all the other movements work in this way.
Turn off the transmitter using the STOP button, and make sure that on doing
so the relays are deactivated and the DATA, ID and SIGNAL LED’s go out.
They behave exactly as in ‘SCANNING’ mode.
Reconnect the power supply to the motors, move to the usual work position
and check to see if all the motion and the stop button are functioning correctly.
