________________________________________________________________________________________
7 of 24
Inserting the AKKULIFT
®
into the Bathtub
1. Make sure that the bottom of the empty
bathtub is clean. Remove any non-slip
mats from the bathtub.
2. Insert the seat frame into the empty
bathtub. The rear suction cups should be
located at the bevelled edge of the
bathtub.
3. Press down the suction lever of the front
mid suction cup. This automatically
adjusts the mid suction cup to the bottom
of the bathtub and fixes it into position
(see Figure 1).
4. Place the backrest with cover on the frame
in the bathtub. Then insert the guide pins
of the backrest into the bearing blocks of
the frame, as shown in Figure 2.
Attention: Always make sure that both
guide pins are inserted in the bearing
blocks!
5. Take the manual control lever in one hand
and pull it away from the lift until the cable
is slightly tensioned.
6. Take the hand grip with the other hand
and fold up the backrest until it reaches
the stop position of the base-plate (see
Figure 3).
Figure 1
Figure 2
Figure 3
Bearing block
Guide pin (red)
Hand grips