10
PACKAGING / HANDLING
UNPACKING
1. Check cartons for any obvious damage to packaging or contents. If damage is evident, contact your local Drive
Medical dealer/provider.
2. Remove any loose packaging from the cartons.
3. Carefully remove all components from the cartons.
TOOLS REQUIRED
• Wire Cutters
• Utility Knife
CAUTION
Unpack the bed in an area with sufficient room to work. Do not allow residents/patients near the bed until it has been
completely set up and the work area has been cleared of all debris.
!
Packaging
The Two Cartons will contain the following components:
15005LP
#15215P
HeadSpring and Head Board w/casters
#15216P
Foot Spring and Foot Board w/ junction box, 3 motor/actuators, Hand Pendant Control, Emergency
Crank Handle.
15004P
#15210P
HeadSpring and Head Board w/casters for 15004P & 15003P
#15212-LP
Foot Spring and Foot Board w/ junction box for 15004P, 2 motor/actuators, Hand Pendant Control.
15003P
#15210P
HeadSpring and Head Board w/casters for 15004P & 15003P
#15211P
Foot Spring and Foot Board, manual 3 crank for 15003P
OPERATING TEMPERATURE
If bed has been stored in an area where the temperature is above or below the Recommended Operating Temperature
range of 41°F to 104°F. You must wait at least 30 minutes for the bed temperature to adjust to the Recommended
Operating Temperature range of 41°F to 104°F before use.
BED SERIAL NUMBERS
When ordering parts or when contacting Drive DeVilbiss Healthcare Customer Service Department, please include bed’s
model and serial numbers, found on the identification labels as below. The identification labels are located under the sleep
deck on the either side of the bed frame.
COMPLIANCE INFORMATION
Matching the correct bed components to meet regulatory specifications can be complicated. Drive DeVilbiss Healthcare
offers a wide variety of compliance options and we can assist your facility in selecting components or accessories that are
recommended for the specific bed model.
Summary of Contents for 15003P
Page 5: ...3 WARNING LABELS...
