S8 Aviator
Owner’s Handbook
Page 9
To change the temperature to ºC or
ºF
:
1.
Press the MODE button until the
temperature is shown on the display.
2.
Hold down the MODE and SET buttons
until the clock starts flashing.
3.
Then press the MODE button until the
temperature gauge is flashing.
2.
Then press SET to change to the
required setting.
3.
Hold down the MODE and SET buttons
for 2 seconds.
When the scooter is first switched on, all the
display will light up for 3 seconds whilst the
scooter runs a self test.
If the scooter finds an error during this time or
during operation error will show on the display,
the red ERROR light will flash and the ERROR
function will light on the display.
The scooter will diagnose the fault and show
this by flashing the red ERROR a number of
times in a sequence, followed by a long pause.
Count the number of flashes in the sequence
and refer the table below:
No.
Error
Remedy
2
Low Voltage
Recharge battery
3
Over Voltage
Restart scooter
4
Over Current
Switch off scooter and
restart after 5 minutes.
5
Parking
Brake
Check scooter is not in
freewheel mode
6
Speed Lever
Not Aligned
Restart scooter with
speed lever released
7
Lever Error
Contact Dealer
8
Motor Error
Contact Dealer
9
Other
Contact Dealer
BATTERY CHARGING
OPERATING INSTRUCTION
Plug in the power cord. The LED will flash green
when mains power is on.
Connect the battery charger to the battery.
Start charging; the charger LED should show
one of the states below:
Green Flash: Power On
Orange Flash: Pre Charge
Orange: Charging
Green & Orange Flash: Charged 80%
Green: Full Charged
Red Flash
：
Defective
The scooter should be charged for 12 – 14 hours
for a full recharge. Failure to do this could result
in a reduced range.
LED DESCRIPTION
(1) Green Flash: Power on
(2) Orange: Charging
(3) Orange Flash: Pre charge
(4) Green & Orange Flash: Charged 80%
。
(5) Green: Full charged (Floating charge)
(6) Red Flash: Defect
TROUBLE SHOOTING
If the LED is not lit
：
Check the mains power. If the socket is
working then the charger has an error.
If green LED keeps flashing and cannot turn
orange or green
：
Check that the battery connector is
connected properly.
