12
Instructions for use GIGO
Drive Medical GmbH & Co. KG | As per: 22.07.2020 | Errors and alterations excepted
EN
Height adjustment of push handles
Insert push handles at least to the first cross hole into the
frame tubing. Insert the fixing screw from the inside and
tighten using the washer and star screw (
pic. 4
).
To change the height adjustment of the push handles,
loosen the fixing screw by turning the star screw counter-
clockwise. Then lock the handle at the desired height, as
described above (
pic. 5
).
4
5
Adjusting the brakes
If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (
pic. 6
) or using the
adjusting screw on the Bowden cable below (
pic. 7
) to
achieve the desired braking effect.
6
7
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.
Braking | Parking
To brake when walking with the rollator, pull both brake
handles upwards with your hands (
pic. 8
). Always brake
slowly while applying equal pressure with both hands.
To apply the brakes/park the rollator, press both brake
handles downwards until they audibly click into place
(
pic. 9
)! To release the brake, pull both brake handles up-
wards once again until they are released (brake handles
are in the middle position).
8
9
The braking effect can be impaired by wear and tear on
the tires. For this reason, regularly check the braking
effect.
Sitting
10
11
NOT PERMITTED!
Place the rollator on an even and solid surface. Then ap-
ply the brakes. The rollator must be stable and may not
slip. Only sit upright; do not lean backwards(
pic. 10
)!
Seated position permitted only as shown and against the
direction of movement (
pic. 11
)!
Folding | Transporting | Stowing
To fold up the rollator, pull the locking lever towards you
and use the handle to pull the seat section upwards (
pic.
12-13
).
Remove accessories, if necessary!
12
13
