www.petfountain.com
FOUNTAIN: CLEAN ONCE A WEEK
(For identification of parts in bold refer to parts diagram on page 1)
FOUNTAIN DISASSEMBLY & CLEANING
WARNING: When cleaning your fountain, do not use any abrasive
cleaning solutions, sponges, or pads. These abrasive surfaces can
scratch the stainless steel parts. The Fountain Must Be Cleaned
Regularly To Continue Working Normally!
FILTERS:
1) Filters should be changed approximately every two weeks. Replace
filters more frequently when using the fountain for multiple pets or pets
that produce a lot of saliva.
2) Filters are an added feature of the fountain. Their use is not required for
normal operation.
3) For replacement filters, visit a pet store near you or call 866-322-2530.
13) Place fountain in desired location. To take care of your floors, we suggest
to
always
use a protective mat or other durable, water resistant surface.
This will help protect your floor from any water that may splash out from
your pet’s use of the fountain.
14) Fill the fountain bowl with water. Make sure the water level is
at least
to
the MIN Fill Line so the pump does not run dry. This will prime the pump
for use. Do not fill the fountain past the MAX Fill Line.
15) Before plugging the fountain into electricity, make sure the cord and your
hands are completely dry. Plug the fountain in.
16) Add water as needed.
Never
let the water level fall lower than the MIN
Fill Line (approx. 1” above the bottom of the bowl) or the pump may fail.
To properly pick up the fountain, use both hands and grip underneath
the sidewalls of the bowl and lift.
IMPORTANT:
Never pick up a full
fountain by the Cone piece!
1) Unplug fountain from electrical source and disconnect the inline plug.
(See Fig. 2)
2) Remove the
flow control cap
and
spout ring
.
3) Next, remove the three
cord clips
by gently pulling the two-prong clip
up and away from the bottom of the bowl. Set the cord clips aside.
pg. 4
