www.petfountain.com
8) Look into the cone opening and make sure
the intake tube is sticking straight up from the
motor. (See Fig. 8a) Carefully, insert the Filter
Housing into the cone opening and push
straight down. (See Fig. 8b) By pushing the
Filter Housing all the way down to the rubber
gasket, the housing should easily attach to
the intake tube.
9) Select one of the five interchangeable spouts
based upon your personal preference or your
pet’s. Place the chosen spout on top of Filter
Housing Lid and gently press down to secure
in place.
10) On the Filter Housing Lid, align the Flow
Control Cap with the raised notches (Fig. 10).
Press down gently and the cap will snap into
place. With the Flow Control Cap, you will be
able to easily adjust the intensity of the water
flow. Turn the cap to the
right
to increase the
flow of water and turn to the
left
to decrease.
11) Take one of the plastic cord clips and align
with the electrical cord hanging over the rim
of the bowl. With the two-prong end on the
outside of the bowl (See Fig. 11a), slide the
cord clip all the way down until it clips onto
the bottom of the bowl. (See Fig. 11b)
12) Take the other two plastic cord clips and
attach them to the bowl so that the three clips
together form the three points of a triangle.
(See Fig. 12) This will lock the cone in place.
Fig. 8a
Raised Notches
Fig. 8b
Fig. 10
Fig. 11a
Fig. 11b
Fig. 12
pg. 3
