Page 11
For technical questions, please call 1-800-444-3353.
Item 69947
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
General Operating Instructions
1. Make sure that the Switch/Trigger is in
the off-position, then plug in the tool.
2. Set Direction Switch to correct position.
a. For clockwise (forward) rotation,
push it from the right side.
b. For counterclockwise (reverse) rotation,
push it from the left side.
NOTIcE:
Do not change rotation
direction while the Chuck is rotating.
3. Verify bit is securely locked in Chuck.
4. For continuous drilling, press Trigger,
then Trigger Lock Button on side
of handle, and release Trigger.
To release lock, momentarily press Trigger.
cAUTION!
Use both hands during use.
5. Use the Depth Gauge for controlled depth
drilling. Markings are not precise values,
only general guides. To set gauge:
a. Insert bit and tighten Chuck.
b. Loosen Side Handle, place tip of bit
against solid surface and extend Depth
Gauge until it is against same surface.
c. Determine required hole-depth and
retract Gauge accordingly.
d. Tighten Side Handle.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
Metal Drilling Tips
1. Use a center punch (not included) to
create a dimple for the bit to start.
2. Start by drilling slowly to keep
bit from wandering/skating away
from your starting point.
3. When drilling large holes in metal, start
by drilling a smaller pilot hole, then using
a larger bit for the final size hole.
Wood Drilling Tips
1. Use bits specially designed for
wood drilling, such as brad point,
spade bits, forstner bits, etc.
2. Start by drilling slowly to keep bit from
wandering away from starting point.
Increase speed as hole is established.
3. To prevent or reduce “break out” when bit
penetrates work piece, clamp a piece of
scrap material to back of work piece.
Masonry Drilling Operation
1. Adjust the Side Handle as needed.
2. Set the Function by adjusting the
Function Switch to the desired setting.
3. Plug in the Power Cord.
4. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
5. Do not apply excessive force,
allow the tool to do the work.
concrete Drilling Tips:
a. Do not add water to the drill hole.
b. Clean the bit flutes regularly while drilling.
c. Back the bit out of the hole
often during drilling, especially
when drilling deep holes.
d. Use the shortest bit practical.
e. When drilling deep holes, work in stages,
use a short bit for the beginning of the hole,
then change to a longer bit.
Summary of Contents for 69947
Page 1: ......
