Page 9
For technical questions, please call 1-800-444-3353.
SKU 46055
OPERAtIOn
Before plugging in Saw, make sure the
1.
Switch (2)
operates without sticking. It
must spring back to the original position
once depressed.
note:
Rotate the
Speed control Switch (1)
from 0-6 to increase the speed of the
blade.
note:
Make sure your workpiece is securely
fastened down.
Draw a cutting line on your workpiece.
2.
Plug in the Saw and turn it on. Wait until
3.
the blade achieves maximum speed.
Figure 3
4.
Rest the bottom base of the Saw on the
workpiece and move the blade forward.
Do not push hard. Let the saw work at
its own rate. Do not force the blade.
See Figure 3.
note:
Make sure the bottom base is level
with the workpiece, or the blade could
break.
note:
Unplug tool before making
adjustments.
Figure 4
5.
Your Jigsaw can be adjusted from 0° to
45° for miter cuts by loosening the bolt
on the bottom of the base with the
hex
Spanner (32)
. See Figure 4.
note:
After loosening the bolt, tilt the base
and use the numbered gradient gauge
on the housing of the saw for an
accurate angle. Tighten bolt.
Figure 5
6.
By loosening the same bolt as in Figure
4, you can slide the base back for cutting
the front plane of a workpiece.
See Figure 5.
