User Manual
ELECTRIC STOVE BUILT-IN | ALEMANIA 30
22
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after
installation (see picture).
CAUTIONS
1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
2. The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers and rotary
dryers.
3. The ceramic cooker hob shall be installed such that better heat radiation can be ensured to
enhance its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
7. This ceramic can be connected only to a supply with system impedance no more than 0.427
ohm. In case necessary, please consult your supply authority for
System impedance information...
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
The power supply should be connected in compliance with the relevant standard, or a single-
pole circuit breaker. The method of connection is shown below.
1. If the cable is damaged or needs replacing, this should be done by an after-sales technician
using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and that it
complies with safety regulations.
