07-02292A F571-115V
6
Dri-Eaz Products, Inc.
Inspect, vacuum or replace filter.
Replace filter when
visibly dirty.
Monthly
Inspect coils
. Clean when dust accumulation is visible.
In normal use, dust can accumulate and can restrict air-
flow, reducing performance and causing the unit to over-
heat. Use a vacuum cleaner with a brush tool and a soft
cloth to remove any debris. Take care not to damage
any interior components.
To maintain appearance
, wipe interior and exterior sur-
faces with a damp cloth. For deep cleaning and a last-
ing, protective shine, use an automotive interior cleaner.
As Needed
Clean pump check valve and basin.
If the unit displays
the message “ER9 PUMP BLOCKED PUMP & HOSE”,
the pump check valve and pump basin may need to be
cleaned. Remove grills and cover as shown in Fig. B.
Remove screws from pump base and lift out pump. Wipe
out pump basin with a damp cloth. Inspect the pump
base for build-up of debris and clean if needed. Un-
thread barbed fitting with check valve and rinse fitting
and check valve with clean water. Reinstall check valve
into barbed fitting and install the barbed fitting into pump.
Do not overtighten. Reinstall pump on base. Reinstall
cover and grills.
Clean coils.
With the cover removed, inspect both coils.
If excessive dust and debris is present, vacuum thor-
oughly and/or clean with coil cleaner.
PUMP PURGE BUTTON
The Control Panel will display the following messages when the Pump Purge Button is pressed.
C O N T R O L P A N E L
M E S S A G E
E X P L A N A T I O N
---
PUMP PURGING XX
Pump is purging with countdown in seconds. Press key again to stop if needed.
