background image

Illustration of Touch pad

READ AND SAVE THESE INSTRUCTIONS

How 

TO USE THE TOUCHPAD CONTROL KEYS

The Touchpad on the Evolution LGR has one display and four keys. The

normal display messages are:

DEHUMIDIFIER OFF

CMPRSR DELAY

DEHUMIDIFIER ON

PUMP PURGING

TOTAL HRS

DEFROST ON

JOB HRS

GET SERVICE ER01

When you first plug in the unit, the touchpad display will cycle con-

tinuously through three messages: DEHUMIDIFER OFF, TOTAL

HOURS, and JOB HOURS

ON-OFF. 

Press the ON-OFF key to turn the unit on or off. When

turning the machine on, usually the display reads CMPRSR

DELAY and performs a numeral count down from a maximum of

60 seconds to 0. The compressor delay gives the machine time to

warm up when needed. If you don't see a compressor delay

countdown. the machine is ready to go. Once the unit completes

the CMPRSR DELAY. the display reads DEHUMIDIFIER ON, and

continues to cycle between TOTAL HOURS, JOB HOURS and

DEHUMIDIFIER ON.

Press the ON-OFF key again to turn the unit off. The display 

wi

ll

read DEHUMIDIFIER OFF.

DISPLAY. Press the DISPLAY key to stop the display at DEHU-

MIDIFER ON or OFF, TOTAL HOURS, or JOB HOURS as it cycles.

Press DISPLAY again to re-start the display cycle.

How to change the language display

CAUTION

While in the change-language mode pressing other keys can
change the programming of the machine. Do NOT press other
keys you're not instructed to press.

Use the DISPLAY key to change the display language.
Follow these steps:

1. Start with the unit unplugged.

2. While holding down the DISPLAY key, plug the unit in.

The display reads ENGLISH.

3, To change to FRANCAIS. DEUTSCH, or ESPANOL.

press the 

DISPLAY 

key or the CLEAR key.

4. 

When the desired language is 

shown 

in the display.

unplug the unit. and the language is set.

CLEAR. 

Press the CLEAR key to reset the JOB HOURS:

1.As the display cycles between DEHUMIDIFIER ON, JOB

HOURS, OR TOTAL HOURS, press the DISPLAY key

when JOB HOURS appears on the screen. That will

make the display read JOB HOURS steadily.

2.Then press the CLEAR key to re-set the numerals to

00000.

3. Press DISPLAY again to re-start the display cycle.

NOTE: 

the TOTAL HOURS reading cannot be re-set.

4

Air Marketing Group ELC

141 Kinderkarnack Rd. Park Ridge. NJ 07656 Tel. 201-782-1782 Fax. 201-782-1783 Web www amgair corn

info@arngair coal

Summary of Contents for Evolution 115v








Reviews: