2
**********ENGLISH**********
PURPOSE OF THE MACHINE
The machine is intended to clean air-driven spray-guns used for painting with water-based paint systems.
PLACING THE UNIT
The DRESTER Quick Rinse is equipment Category 2 (ref. ATEX-directive 94/9 EC) and may therefore be placed in locations
classified as Zone 1 (ref. ATEX-directive 1999/92 EC).
ASSEMBLY & INSTALLATION
The unit is supplied complete in a box. Assemble and install it by following the enclosed sequence of pictures 14453.
The unit must be connected to compressed air of 5-12 bar (80-180 psi). When in use, the unit consumes 100 litres/min (4 cfm) of
air. The compressed air supplied to the unit must be clean and dry. If it is not first led through a water trap and filter, it may cause
damage to the pneumatic components of the unit, which will invalidate any warranty claims.
Make sure that the unit is properly grounded.
This manual is part of the unit and must be kept accessible at all times.
PERMITTED SOLVENTS
The machine is designed for water, or water-based solvents intended for the cleaning of spray-guns that have been used for
painting with water-based paint systems. Flameable solvents like Thinner, gunwash or similar must NOT under any circumstances
be used in this machine.
PREPARATIONS FOR USE
Topping up with water on installation
Described in the sequence of pictures 14453 (ref installation above).
Operating instructions
Operating instructions should be formulated on the basis of this manual and translated into the language spoken by the employees.
It should always be available close to the machine. To avoid confusion, the employees must be informed about the solvent
currently being used in the machine.
OPERATING INSTRUCTIONS
Follow the sequence of pictures at the end of this manual.
SERVICE
Change of water:
Remove the Front Cover (item 7 Picture 1) by first removing the Screw (item 6 Picture 1).
Pull out the suction hose from the pump and fill the Container (item 8 Picture 1) with Water (5 l volume). Put the container back
and insert the suction hose from the pump all the way down.
Empty the can for return water (item 9 Picture 1) into a suitable unit where the return water can be separated from the paint
residuals by using the “Floculation technology”, after wich the return water can be drained off into a regular drain water system
(this must however be confirmed by the local water authoroties). Such units are the DRESTER gun cleaner units 1000, 950, 9000-
TT, 1200 and 2000-TT.
Put the can back into the machine.
Refit the Front Cover.
Other:
Replace the brush (item 5 Picture 1) whenever needed.
