US510, US520 & US540 –
Metal, Masonry and Diamond
Tile Wheels
Follow OSHA and ANSI
b 7 . 1 s t a n d a r d s . U s e
wheel to cut only materials for which it is
intended. Do not use for wet cutting. Wear
body apron and gloves. Mount wheel with
tool flanges provided. Run-in for one minute
before application. Do not jam, twist or
pinch wheel in workpiece or apply excessive
side pressure to wheel. KICKbACK may
occur if wheel is jammed. Do not position
your body in line with wheel. Do not use
near flammable materials or gases, fire or
explosion may result. Do not expose to
water, condensation or freezing. Do not
touch wheel immediately after use as it may
still be hot. Discard wheel if dropped,
cracked or chipped.
In addition to the warnings for the US510,
U S 5 2 0 a n d U S 5 4 0 p l e a s e r e f e r t o t h e
following warnings.
US500 and US600 – Wood &
Plastic Carbide Wheel and
Wood & Plastic Flush Cut
Carbide Wheel
Use wheel to cut only materials for which it
is intended. Mount wheel with tool flanges
provided. Do not jam, twist or pinch wheel
i n w o r k p i e c e o r a p p l y e x c e s s i v e s i d e
pressure to wheel. KICKbACK may occur if
w h e e l i s j a m m e d . F o l l o w i n s t r u c t i o n s
outlined in Auxiliary Handle section, on page
16. Auxiliary handle required when using
US600. Do not position your body in line
w i t h
w h e e l .
D o
n o t
t o u c h
w h e e l
immediately after use as it may still be hot.
US410 – Diamond Surface
Prep Wheel
Auxiliary handle required. Do not use with
Dremel SawMax. Clean tool guard after
use.
-7-
Additional Safety Warnings
