INSERTING BITS
Your tool is equipped with a bit holder
1
.
Simply push a bit
10
into the bit holder
1
as far
as it will go (Fig. 1).
DIRECTION OF ROTATION
To prevent damage to the
tool, do not use the
direction of rotation switch while the power
tool is in operation.
Clockwise rotation:
To drive screws in, slide
the direction of rotation switch
2
down or
forward to position
A
(Fig. 2).
Counterclockwise rotation:
To loosen or
unscrew screws, slide the direction of rotation
switch
2
up or backwards to position
B
(Fig. 2).
Locking the shaft in place:
To lock the shaft
(bit holder
1
) in place, slide the direction of
rotation switch
2
into the middle position
C
(Fig. 3). This enables screws to be screwed in
manually, e.g. when the battery is depleted.
To prevent accidental
activation of the tool,
slide the direction of rotation switch to
middle (locked) position when storing or
transporting the tool.
SETTING THE TORQUE
The required torque can be set in one of six
positions using the torque selector
4
. The tool
will stop as soon as the set torque is reached.
Position 1
: Lower torque for screwing in
screws with small diameter or into soft
materials.
Position 6:
Higher torque for screwing in
screws with large diameter or into hard
materials.
STARTING AND STOPPING THE TOOL
To start the power tool, put pressure on the bit
holder
1
and maintain this pressure to continue
using the power tool. To switch the tool off,
stop putting pressure on the bit holder
1
.
FASTENING WITH SCREWS
The procedure shown in figure 4 will enable
you to fasten materials together with your
Cordless Screwdriver without stripping,
splitting, or separating the material.
First, clamp the pieces together and drill the
first hole 2/3 the diameter of the screw. If the
material is soft, drill only 2/3 the proper length.
If it is hard, drill the entire length.
Second, unclamp the pieces and drill the
second hole the same diameter as the screw
shank in the first or top piece of wood.
2.
Drill same
diameter as
screw shank.
3.
Countersink
same
diameter
as screw
head.
1.
Drill 2/3 diameter and
2/3 of screw length for
soft materials, full
length for hard
materials.
Screw
Apply a slight
even pressure
when driving
screws.
FASTENING
WITH SCREWS
Operating Instructions
2
1
2
A
B
4
2
C
1
1
Fig. 2
Fig. 3
Fig. 4
-10-
