6
Battery/Charger
Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2) bat-
tery pack, and (3) product using battery.
Use only the charger which accompanied your prod-
uct or direct replacement as listed in the catalog or
this manual.
Do not substitute any other charger. Use
only Dremel approved chargers with your product. See
Functional Description and Specifications.
Do not disassemble charger or operate the charger if
it has received a sharp blow, been dropped or other-
wise damaged in any way. Replace damaged cord or
plugs immediately.
Incorrect reassembly or damage
may result in electric shock or fire.
Do not recharge battery in damp or wet environment.
Do not expose charger to rain or snow. If battery case
is cracked or otherwise damaged, do not insert into
charger.
Battery short or fire may result.
Charge only Dremel approved rechargeable batteries.
See Functional Description and Specifications. Other
types of batteries may burst causing personal injury and
damage.
Charge battery pack in temperatures above +32
degrees F (0 degrees C) and below +113 degrees F
(45 degrees C). Store tool and battery pack in loca-
tions where temperatures will not exceed 120
degrees F (49 degrees C).
This is important to prevent
serious damage to the battery cells.
Battery leakage may occur under extreme usage or
temperature conditions. Avoid contact with skin and
eyes.
The battery liquid is caustic and could cause
chemical burns to tissues. If liquid comes in contact
with skin, wash quickly with soap and water, then with
lemon juice or vinegar. If the liquid contacts your eyes,
flush them with water for a minimum of 10 minutes and
seek medical attention.
Place charger on flat non-flammable surfaces and
away from flammable materials when re-charging
battery pack.
The charger and battery pack heat during
charging. Carpeting and other heat insulating surfaces
block proper air circulation which may cause overheat-
ing of the charger and battery pack. If smoke or melt-
ing of the case are observed unplug the charger imme-
diately and do not use the battery pack or charger.
Use of an attachment not recommended or sold by
Dremel may result in a risk of fire, electric shock or
injury to persons.
Battery Care
When batteries are not in tool or
charger, keep them away from
metal objects.
For example, to protect terminals from
shorting
DO NOT
place batteries in a tool box or pocket
with nails, screws, keys, etc. Fire or injury may result.
DO NOT PUT BATTERIES INTO FIRE OR EXPOSE TO
HIGH HEAT.
They may explode.
!
WARNING
DM 2610011275 05-10:DM 2610011275 05-10 5/6/10 10:38 AM Page 6
