ATTACHMENT FOR USE WITH DREMEL
ROTARY MODELS 275, 285, 395, AND
398
ATTENTION:
Read entire instruction
manual carefully before using your Dremel
Shaper/Router Table. Retain instructions for
future reference. This attachment will
convert Dremel Corded Rotary Tools to a
Shaper/Router Table for edge forming,
routing, grooving, shaping, sanding edges,
jointing, etc.
NOTE: Not for use with cordless rotary
tools. Not for use in conjuction with the tile
cutting bit, model 562.
Mount Table to Workbench
The
SHAPER/ROUTER TABLE
comes
assembled ready to mount to the
workbench. After determining table
location, predrill the bench using a 1/8”
diameter drill at the four
MOUNTING HOLE
locations. Secure table to the bench using
the
(4) #10 x 1” WOOD SCREWS,
and
WASHERS.
(Included with the
Shaper/Router Table).
(See Fig. 1)
Install Rotary Tool to Table
1. Check the model number of your rotary
tool and use the listing below to
determine which bushing to use when
adapting your tool to the Shaper/Router
table.
2. Loosen the two
CLAMPS NUTS
several
turns. Insert the tool into both clamps
then align the switch to the split in the
clamps
(switch will be to the right —
giving a front to rear motion for
turning motor off).
Be sure nose is
seated all the way in small clamp.
Secure tool by tightening the two clamp
nuts.
(See Fig. 2 & 3)
-4-
ROTARY TOOL MODEL
BUSHING REQUIRED
275, 285, 395 (Type I, II, IV, V) . . . . . . . . USE: Black Bushings in small clamp.
398 Professional
(4) #10 X 1”
WOOD SCREWS
& WASHERS
GUARD
MOUNTING
HOLE
FENCE
CLAMPS
CLAMP NUTS
SWITCH IS TO THE
RIGHT SO FRONT TO
REAR MOTION WILL
TURN UNIT OFF
Fig. 1
Fig. 2
DM 2615302562 9/00 9/21/00 9:20 AM Page 4
