6
EN
in green on the (3) LED Display (6) Diagram [C].
TIMER OFF/STANDBY: When the set time period has elapsed, the blanket will automatically switch off
and the standby light will be illuminated in blue on the (3) LED display (10) Diagram [C]. If you wish to
switch your blanket back on again, press the timer button (7) Diagram [C] selecting either 1 or 9 hours.
MANUAL SWITCH OFF BOTH BLANKET AND CONTROL: Switch off the back of your Intelliheat control
(11) Diagram [C] to off (O) position.
MEMORY FUNCTION: After using your blanket for more than 5 minutes, the Intelliheat control will
remember your last temperature setting.
DISCONNECT: To disconnect your electric blanket from the mains socket, switch the control to OFF
position on the back of your Intelliheat control (O) (11) (Diagram [C]), and then safely disconnect the plug
from the mains socket.
CLEANING AND MAINTENANCE
Your mattress protector is suitable for washing. Check the washing instructions on the label of your
mattress protector to wash it correctly.
WARNING! Always disconnect the appliance from the mains
supply before cleaning or performing maintenance.
BEFORE WASHING OR STORING YOUR MATTRESS PROTECTOR:
1. Disconnect the control from the mains socket.
2. Disconnect the connector (2) from the mattress protector by pressing the push buttons at the sides of the
control connector (1).
3. Ensure that the controls are not connected and none of the wires have worn through the fabric.
4. It is important to measure the mattress protector before washing and check that the dimensions are
approximately the same before drying.
MACHINE WASHING
• The mattress protector can be machine washed at 40°C on a wool programme.
• Only the gentle spin cycle is to be used. DO NOT use an extra spin cycle.
TUMBLE DRYING
• Tumble dry at a low temperature.
• DO NOT use the mattress protector until it is completely dry.
HANGING THE MATTRESS PROTECTOR OUTSIDE TO DRY
WARNING! Hang the appliance without using pegs on the wired
area of the mattress protector so as not cause any damage to it.
• The mattress protector must be stretched back to approximately its original size during the drying
process. This is best done whilst damp, working from side to side, stretching a piece at a time. This
procedure may need to be repeated a few times until fully dry.
• Make sure the wires are not kinked or twisted. It is easier to check the wires by placing the mattress
protector against the light.
• If problems arise with the wires after having dryed the mattress protector or if it does not return to its
original size, return it to our authorised Service Centre for a safety check.
WARNING! Examine the appliance against the light to make
sure the cables are not bent or twisted.
